Cassese CS200 CART, Руководство пользователя и каталог запчастей

Страница: 20 / 64

USER MANUAL CS200 CART
20
5 MAINTENANCE
5.A SAFETY INSTRUCTIONS
5.B MAINTENANCE PLAN
5.B.a Daily maintenance:
It is recommended once a day to clean the table surface with a clean cloth and make sure there is no debris in the distributor
head. If some glue is remaining in the distribution block, then perform procedure 5.C REMOVING THE DISTRIBUTOR HEAD (page
21) and 5.D LUBRICATING THE DISTRIBUTOR HEAD (page 22). It is important to avoid glue from drying in the distribution head as
it could prevent the cartridge from going in the distribution block correctly.
5.B.b Regular maintenance:
Once a week it is recommended to clean and lubricate the distribution block. Refer to following chapter to perform this
maintenance:
5.A
SAFETY INSTRUCTIONS (page: 20)
5.C REMOVING THE DISTRIBUTOR HEAD (page 21)
5.D LUBRICATING THE DISTRIBUTOR HEAD (page 22)
Rotate red button in EXH position.
Unplug the machine from pneumatic source.
Install a locker to ensure nobody will turn back on the machine while you will be
performing the maintenance.
Figure 5-1
The CS200 CART is using pneumatic air supply. It is essential for your safety to make sure that it is disconnected
prior to make any maintenance. Please refer to instructions below prior to perform any maintenance.
If using compressed air to clean some parts, wear safety glasses. It is even recommended to use a vacuum to
clean the machine rather than compressed air that will spray dust everywhere.
All maintenance and control operations must be carried out by skilled maintenance staff.