EN
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the
device in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
START-UP
The device must be completely removed from its packaging. All protections must be completely removed.
Place the appliance on a solid, flat surface. Never place the electric waffle iron on a flammable surface.
Do not install this appliance near open fires, or other heating appliances.
The electric cable must be protected to at least 16 Amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
Press the switch to turn on the waffle maker.
Heat the unit for 20 minutes until all smoke and odor are gone.
NEVER use cold water on the cast iron plates as you may cause thermal shock.
USE
Plug in the appliance, press the switch, the red light comes on.
Turn the temperature control knob. The temperature can be between 60 ° and 300 ° C.
We recommend that you use this device at a maximum temperature of 220 ° C.
Once the desired temperature has been reached, the red light goes out.
Pour the waffle batter into the center of the baking sheet. Close the appliance and cook for the
recommended cooking time using the timer.
When the temperature decreases, the appliance starts heating again and the red light comes on again.
At the end of use, turn the thermostat to 0 and press the switch in OFF mode.
TIMER
Count up: stopwatch
Count down: timer
'-' and '+': timer setting
Stopwatch
Start press '+' for the stopwatch. To stop, press '+'.
5 beeps to signal the stop of the stopwatch.
Timer
Pressing '-' and '+' simultaneously displays the default value: 10sec.
Press '-' and '+' simultaneously again (2 beeps).
The time flashes, you can set the desired time with '-' and '+' (0.1 - 19.59 mm).
Wait for the screen to go off then press '-' to start the timer.
5 beeps to signal the end of the timer.
