EN
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without supervision.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
START-UP
The device must be completely removed from its packaging. All protections must be fully
withdrawn.
Place the appliance on a solid and flat surface Never place the electric crepe maker on a surface
flammable.
Do not install this appliance near open fires, or other heating devices.
The electric cable must be protected to at least 16 Amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip. Heat the appliance for 10 minutes until all
smoke and odor are gone.
Turn off and unplug the appliance, then use hot soapy water to clean the hot plates.
stainless steel.
NEVER use cold water on the stainless steel plates as you risk causing thermal shock.
USE
Plug in the device, once plugged in, the red light will light up.
Turn the temperature control knob and the green light comes on. The temperature can be understood
between 60 ° and 300 ° C. We recommend that you use this device at a maximum temperature of 250 ° C.
In 10 minutes, the temperature of 250 ° C is reached.
When the desired temperature is reached, the green light goes out.
When the temperature decreases, the appliance starts heating again and the green light comes on again.
The baking sheet does not require seasoning.
NOTE
The device is equipped with a safety system in the event of overheating. If triggered, unplug the device and
allow it to cool. If this protection system operates regularly, it is imperative to contact your dealer.
