22
23
Maintenance
Washing
Firstly, recover any residues of pesticides into a suitable container.
Only use clean and clear water to clean the tank and the entire circuit.
Rinse thoroughly, flushing clean water while the pump is operating,
recovering the liquid as per current regulations.
Check the nozzle clogging and wear conditions.
Battery
Recharge the accumulator after each use of the machine,
in order to maintain its efficiency over time.
In the event of long periods of inactivity of the machine, remove the
battery and store it in a fresh and dry place.
Recharge the battery approximately every three months.
Starting
• Remove the cover
• Pour the mixture into the tank
Fill the tank only after filtering the fluid,
in order not to damage the pump.
Always use clean water without impurities to prepare the liquid to
be sprayed.
• Set the pump operating mode (continuous - timed) by means of
the switch on the side
• If the timing setting is selected, select the desired timing according
to the product millilitres to be dispensed for each spray (check
with the supplied measuring cup)
• SparaMosca is ready to be used
• Spray the chemical product keeping the nozzle at a suitable
distance from the surface being treated.
NOTE: Mix the pesticide separately in a suitable container, then pour
the solution into the tank.
Remember that, on average, approx. 200 ml of product remain
within the pipes at the end of treatment.
Operating instructions
C
Cleaning the solenoid valve
See the solenoid valve specification and components on page 17.
Since the solenoid valve may become clogged, remove and clean
it thoroughly any time it is necessary. To do so: remove the fitted
solenoid (1), unscrew the bulb (2) by 90° until it clicks, using a pair of
pliers, then thoroughly clean the inside of the solenoid valve. Finally
reassemble all components carefully.
