CASO DESIGN 1863, Оригинальное руководство по эксплуатации, Страница: 27 / 83

27
13.2 Control panel
Press the button for about 3 seconds to
unlock. After approximately 10-15 seconds
without operation it locks automatically.
Press the button again to unlock the device.
Set the desired temperature according to
000 (normal temperature water), 45°C,
55°C, 65°C, 75°C, 85°C, 100°C
Set the water volume according to 100ml,
200ml, 300ml, 000 (continuous water flow)
Start and stop function setting.
13.3 Rating plate
The rating plate with the connection and performance data can be found beneath the device.
14 Operation and Handling
This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
Warning
► Do not leave the appliance unsupervised during operation.
14.1 Before initial use
1. Place the device in a safe location and plug it in.
2. Please do not use the filter at this moment yet.
3. Fill the water tank with ca. 2 litres of water.
4. Remove the tray.
5. Place a large bowl in front of the device so that it collects the water that runs out of the
spout.
6. Start the device with 000 temperature setting until the device dispensed water with normal
temperature.
7. Start the device with maximum temperature setting and continuous water flow (see 13.2).
8. After round about 30 seconds the calibration of boiling point is finished and the device
works steadily.
9. When the water tank is empty, the device beeps and the dislay shows E7.
10.
Remove the plug from the wall outlet and let the device cool down.
11. Refill the water tank again with fresh water. The device is now ready to use.