E-28
Handling the Neck Strap
A neck strap can be attached to the Handheld Printer Terminal to keep it from being
dropped while being carried. The stylus holder provided can also be attached.
Neck strap
Adjust length here
Mounting
hooks
Stylus holder
Neck strap rings
*
Attach the neck strap following the
procedure described below.
Attaching
1. Pull out the neck strap mounting hooks
out of each silo on the bottom of the
Handheld Printer Terminal using the tip
of stylus. (On models with a magnetic
card reader, the hooks are located at the
bottom of the terminal on the back of the
reader.) Hook the protrusive part (**)
of the ring on the neck strap mounting
hook as shown in the illustration. While
slightly pushing the ring, turn the ring
until all part of it is fully hooked.
** The ring is very stiff for the
¿
rst time.
A small
À
at screw driver is helpful by
inserting it into overlapped part of the
ring to make a room when hooking the
protrusive part.
2. Pull back the locking bar of the neck
strap mounting hook and then hook the
mounting hook onto the ring as shown in
the illustration.
The illustration shows the IT-9000-20E.
* ; The rings give an extra mechanical strength
for the Neck Strap. The metallic hooks of the
Neck Strap can, in rare case, be worn by abrasion
induced by swinging the IT-9000 terminal
speci
¿
cally when it is hung from the operator's
neck with the Neck Strap. For those who often use
the IT-9000 terminal in a hanging position, it is
recommended to use the rings to secure the Neck
Strap.
x
The illustration shows the IT-9000-20E.
* ; The rings give an extra mechanical strength
for the Neck Strap. The metallic hooks of the
Neck Strap can, in rare case, be worn by abrasion
induced by swinging the IT-9000 terminal
speci
¿
cally when it is hung from the operator's
neck with the Neck Strap. For those who often use
the IT-9000 terminal in a hanging position, it is
recommended to use the rings to secure the Neck
Strap.
x
