E-28
427B-E-032A
L
E
Figure 6
K
K
F
F
Caution
Take care that you do not pinch your fingers between
the keyboard and stand!
Figure 4
2
Installing the Keyboard
onto the Stand
Be sure that you securely anchor the keyboard to the stand
using the
K
butterfly bolts (Figure 6).
• Slide the screws on the bottom of the keyboard into the
slots in the two angle brackets
F
. Next, secure the keyboard
to the stand with two butterfly bolts
K
(Figure 7).
Figure 7
Front
Back
• The butterfly bolts keep the keyboard from falling from the
stand. Be sure that you always secure the keyboard with
the butterfly bolts.
6. Rotate height adjustment screw
H
until it supports cross-
piece
D
, preventing the crosspiece from bending when you
press the pedals (Figure 5).
IMPORTANT!
Be sure to install adjustment screw
H
and perform the ad-
justment procedure described above before depressing the
pedals. Failure to do so can result in damage to crosspiece
D
.
5. Attach back panel
C
to the
E
brackets and crosspiece
D
.
Note that the back panel
C
should be installed so it is in
front of the
E
brackets (Figure 4). Use the two
L
screws,
six
I
screws to secure the back panel in place (Figures 3
and 4). Note that you must also install the second
J
clip at
this time as shown in the illustration.
• First, install the topmost
L
screws on the left and right
sides of the back panel
C
. Note that you should slip the
other
J
clip onto the
I
screw at point
6
before you
screw the
I
screw in.
• The back panel
C
should rest on the feet of side uprights
A
and
B
as indicated by
7
in the illustration. Press the
back panel
C
against crosspiece
D
while installing the
L
screws.
Figure 5
H
(Back)
A
C
B
I
6
J
J
7
L
AP31/33_E_26_30.p65
03.10.22, 5:05 PM
Page 28
Adobe PageMaker 6.5J/PPC