Casio 5658, Руководство по эксплуатации

Страница: 22 / 29

Measuring Lap Times
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
●
If a stopwatch timing operation is in
progress, press (D) to stop it and then
press (A) to reset the stopwatch to all
zeros before performing the operation
in step 2.
2.
Press (A) to display [LAP].
●
Each press of (A) toggles between
[SPL] (split time) and [LAP] (lap time).
Minutes, seconds
3.
Use the operations below to measure
elapsed time.
●
Each time you press (A), the watch
displays the time elapsed (lap time)
since the last lap time operation,
alternating with the stopwatch number
for about eight seconds.
D
A
D
Stop
Start
Lap
●
Elapsed lap time is displayed in 1/100-
second units for the first hour. After that,
it is displayed in one-second units.
First hour After first hour
Minutes, seconds
1/100 seconds
Hours, minutes
Seconds
4.
Press (A) to reset the stopwatch to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Using EDIFICE Connected to
Configure Timer Settings
If the watch is paired with a phone, you can
also use EDIFICE Connected to set the timer
start time.
l
Configuring Watch Settings
Setting the Countdown Start
Time
The start time can be set in 1-second units up
to 60 minutes.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1.
Enter the Timer Mode.
l
Navigating Between Modes
2.
Hold down (A) for at least two seconds.
Release the button when the minutes
setting starts to flash.
This causes the minutes digits to flash.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
Minutes
3.
Use (B) and (D) to change the minutes
setting.
4.
Press (C).
This causes the seconds digits to flash.
Seconds
5.
Use (B) and (D) to change the seconds
setting.
6.
Press (A) to exit the setting screen.
Note
●
Setting a start time of 00’00 will perform
a countdown of 60 minutes.
Using the Timer
1.
Enter the Timer Mode.
l
Navigating Between Modes
Minutes, seconds
2.
Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Measurement operation starts.)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (A).
3.
Press any button to stop the tone.
Watch Operation Guide 5658
22