CCE – Cash Concepts Europe GmbH
Kemptener Straße 99 – D-88131 Lindau / Germany
Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20
Email: [email protected] / Web: www.cce.gmbh
EN
•
Counting speed
The CCE 2060 has three counting speeds, which can be selected in the setup menu. For strongly used notes you should not
work in the highest counting speed, because such banknotes properly can't be drawn in correctly under circumstances. You
can choose between the counting speeds 1 (800 / notes per minute), 2 (1,200 / notes per minute) and 3 (1,500 / notes per
minute).
Mechanical settings
By the transport and by wear of the transport roles in the upper area a post adjustment of the feeder can be necessary. At the
rear side of the machine is a set wheel which can be easily pressed a little down and changes then by tricks the pressure on the
banknotes. The set wheel must be pressed down while adjusting to prevent unintentional changing of the pressure.
If the CCE 2060 draws not only one but also several banknotes, turn the set wheel in the direction of "-" sign and during you press
the set wheel down.
If the CCE 2060 does not draw in the banknotes, turn the set wheel in the direction of "+" sign and during you press the set wheel
down.
Settings in the setup menu
Press the SETUP button to enter the setup menu. Use the arrow keys to navigate in this menu and press START to confirm. Press
the CLEAR button to exit from the submenu and the setup menu.
•
Speed (Counting speed) - Factory setting: 2
Press the START key and use the arrow keys to select the desired counting speed. Confirm the selection by pressing the
START button again.
•
IR SENSITIVITY (Infrared Counterfeit Detection) - Factory setting: ECB
Press the START key and use the arrow keys to select the desired IR level. Please note that decreasing the detection
results in a deterioration of the counterfeit detection. High, ECB (recommended setting), Middle, Low, Closed (no IR
detection). Confirm the selection by pressing the START button again.
•
CLEANING MESSAGE (Machine cleaning message) - Factory setting: YES
Press the START key and use the arrow keys to select whether you want to be reminded periodically to clean the
sensors. Confirm the selection by pressing the START button again.
•
SD Update (Start update)
Press START when you insert an SD card into the device to install the software on the machine.
•
DEF parameter (Load factory setting) - second page in the setup menu
Press the START button twice if you want to reset the machine to the factory setting.
•
TECHNICIAN AREA (Service area) - second page in the setup menu
This password protected area is only available to authorized service technicians.
