IOM-BQ
6
b. Reg u la tor “Model” identi
fi
er.
c. Size (may have to ob serve body tap).
d. Spring range.
e. Trim des ig na tion num ber (if avail able).
Step 2. De ter mine con struc tion of trim.
a. Metal or com po si tion (soft) seat?
b. Is 316 SST need ed over stan dard 416 SST?
c. What material are the gas kets? (Our stan dard non-
asbestos is light gray in color, and TFE is fawn.)
Step 3. With the information from Steps 1 and 2 above, contact
your local Cashco, Inc., Sales Rep re sen ta tive for the
proper iden ti
fi
ca tion numbers to use, and the parts
costs.
METHOD C - NO PRODUCT CODE AVAILABLE
- AS SEMBLED REGULATOR IN SERVICE.
Step 1. De ter mine all avail able in for ma tion from metal tag us ing
Step 1, Method B.
Step 2. Con tact your lo cal Cash co, Inc., Sales Rep with the
above in for ma tion.
Step 3. Sales Rep re sen ta tive will con tact the factory to de-
ter mine the original internal construction. Fac tory will
relay information to the Sales Rep re sen ta tive.
Step 4. Await the Sales Representative
ʼ
s return contact with
the proper part numbers and cost.
SECTION VIII
VIII. PARTS ORDERING INFORMATION
There are three methods to obtain parts ordering information/numbers. These methods are listed below, in order of ease of
entering. The least expensive method is to utilize parts in kits where possible.
METHOD A - USE OF PRODUCT CODE.
Step 1. If available, obtain the 18 character product code num-
ber from:
a. The Bill of Materials sheet attached herein
b. The metal tag attached to the regulator.
NOTE:
Some regulators may not have the prod uct
code lo cated on the metal tag.
Step 2. Identify which kits or parts are desired from the fol-
low ing:
a. The Bill of Materials sheet attached herein, or refer
to the cross-sectional drawings.
b .Standard maintenance parts for a basic regu la tor
(no options) are included in the Parts Kit Num ber
table below. Kit “A” con tains seal(s), diaphragm(s)
and gasket(s). Kit “B” contains trim re place ment
parts plus seal(s), diaphragm(s) and gasket(s).
Step 3. Contact your local Cashco, Inc., Sales Rep re sen ta tive
and specify the product code number along with a
description of any parts not included in the kits below.
Costs of re quired parts (and kits) can be given by the
Sales Rep re sen ta tive.
METHOD B - NO PRODUCT CODE AVAILABLE
- DISASSEMBLED REGULATOR.
Step 1. Determine all available information from regu
la tor's
metal tag.
a. Se ri al num ber (5-dig it).
7 -
-
The shaded parts kits numbers below represent an abbreviated
identi
fi
cation number for a basic regulator (no options).
MODEL BQ
PARTS KIT NUMBERS
(KIT NOS. SHADED)
TRIM
DISIG. NO.
KIT
ABBR.
SIZE
1/4", 3/8" & 1/2" (DN8, 10 &15)
B0 & B5
A
1B2-ABOK-A
BO
B
1B2-BBOK-A
B2
A
1B2-AB2K-A
B
1B2-BB2K-A
B5
B
1B2-BB5K-A
S1 & S36
A
1B2-AS1K-A
S1
B
1B2-BS1K-A
S36
B
1B2-B36K-A
