Case SV208D, Руководство по обслуживанию

Страница: 13 / 31

INTRODUCTION
Wheels and tires
Make sure that tires are correctly inflated. Do not exceed any recommended load or pressure. Follow the instructions
in the manual for proper tire inflation.
Tires are heavy. Handling tires without proper equipment could cause death or serious injury.
Never weld on a wheel with a tire installed. Always remove the tire completely from the wheel prior to welding.
Always have a qualified tire technician service the tires and wheels. If a tire has lost all pressure, take the tire and
wheel to a tire shop or your dealer for service. Explosive separation of the tire can cause serious injury.
DO NOT weld to a wheel or rim until the tire is completely removed. Inflated tires can generate a gas mixture with
the air that can be ignited by high temperatures from welding procedures performed on the wheel or rim. Removing
the air or loosening the tire on the rim (breaking the bead) will NOT eliminate the hazard. This condition can exist
whether tires are inflated or deflated. The tire MUST be completely removed from the wheel or rim prior to welding
the wheel or rim.
Driving on public roads and general transportation safety
NOTICE: The standard type of the machine is not intended for driving on public road. When on the road, the machine
should be transported on a vehicle. In the unavoidable situation to drive the machine on public roads for shorter
distances, follow the below safety precautions.
Comply with local laws and regulations.
Use appropriate lighting to meet local regulations.
Make sure that the SMV emblem is visible.
Use safety chains for trailed equipment when safety chains are provided with machine or equipment.
Lift implements and attachments high enough above ground to prevent accidental contact with road.
When you transport equipment or a machine on a transport trailer, make sure that it is properly secured. Be sure the
SMV on the equipment or machine is covered while being transported on a trailer.
Be aware of overhead structures or power lines and make sure that the machine and/or attachments can pass safely
under.
Travel speed should be such that you maintain complete control and machine stability at all times.
Slow down and signal before turning.
Pull over to allow faster traffic to pass.
Follow correct towing procedure for equipment with or without brakes.
Fire and explosion prevention
Fuel or oil that is leaked or spilled on hot surfaces or electrical components can cause a fire.
Crop materials, trash, debris, bird nests, or flammable material can ignite on hot surfaces.
Always have a fire extinguisher on or near the machine.
Make sure that the fire extinguisher(s) is maintained and serviced according to the manufacturer’s instructions.
At least once each day and at the end of the day, remove all trash and debris from the machine especially around hot
components such as the engine, transmission, exhaust, battery, etc. More frequent cleaning of your machine may be
necessary depending on the operating environment and conditions.
48150518 26/02/2018
8