Case 621F, Руководство по обслуживанию

Страница: 48 / 51

2000-17
STEP 79
BD02N160
Check and make sure that drain caps are tight.
STEP 80
Install a new oil filter on engine. Fill engine with 13.25
liters (14 U.S. quarts) of Case AKCELA Engine Oil
(SAE 15W-40).
STEP 81
If hydraulic reservoir was drained, fill reservoir with
90.8 liters (24.0 U.S. gallons) of Case AKCELA
Hy-Tran Ultra® fluid.
STEP 82
Fill engine coolant system with a solution of 50%
Ethylene Glycol and 50% water. Cooling system
capacity is 28.4 liters (30.0 U.S. quarts). Install the
radiator cap. Fill the coolant reservoir up to the FULL
mark on the reservoir.
STEP 83
Connect the batteries, install battery covers, put
master disconnect switch in ON position.
STEP 84
Start engine and run the engine at low idle. Run the
engine at operating temperature for approximately
five minutes to completely mix the Ethylene Glycol
a n d w a t e r . W h e n t h e c o o l a n t i s a t o p e r a t i n g
temperature, stop the engine. When engine has
cooled, check the coolant level at the reservoir.
WARNING:
Hot coolant can spray out if radiator cap
is removed. To remove radiator cap: Let system cool,
turn to first notch, then wait until all pressure is
released. Scalding can result from fast removal of
radiator cap.
STEP 85
BD06F108
Lower the hood with the hood lift motor.
STEP 86
Put articulation lock in OPERATING position.