Case IH STX275, Руководство по обслуживанию

Страница: 13 / 51

1001-3
Rac 7-90470 Printed in U.S.A.
Template Name: SM_2_col
Template Date: 1997_01_13 Alt= to hide template information
Alt+ to display template information
ROLL OVER PROTECTIVE
STRUCTURE (ROPS)
ROPS, the operators seat, the seat belts and all
m o u n t i n g , a c c e s so r i e s a n d w i r in g i n s i d e t h e
operators protective system must be carefully
checked after a tractor accident and all parts with
damage must be replaced immediately. DO NOT
TRY TO MAKE REPAIRS OR WELD THE ROPS.
Safety Rules:
1. Do not make modifications to the ROPS.
Example, welding an accessory to the ROPS or
drilling a hole in the ROPS.
2. Special fasteners are used to install the operator
protective parts. Replacement parts must be the
same as given in the Parts Catalog.
WARNING: Lower all attachments to the
ground or use stands to safely support the
attachments before you do any maintenance
or service.
M496
WARNING: Hydraulic oil or diesel fuel
leaking under pressure can penetrate the
skin and cause infection or other injury.
To Prevent Personal Injury:
Relieve all pressure, before disconnecting
fluid lines. Before applying pressure, make
s u r e a l l c o n n e c t i o n s a r e t i g h t a n d
components are in good condition.
Never use your hand to check for suspected
leaks under pressure.
Use a piece of cardboard or wood for this
purpose. If injured by leaking fluid, see your
doctor immediately.
SM171A
WARNING: When removing hardened pins
such as a pivot pin, or a hardened shaft, use
a soft head (brass or bronze) hammer or use
a driver made from brass or bronze and a
steel head hammer.
M497
WA RNI NG: W h en using a ha mm er t o
remove and install pivot pins or separate
parts using compressed air or using a
grinder, wear eye protection that completely
encloses the eyes (approved goggles or
other approved eye protectors).
M498
WARNING: Use suitable floor (service)
jacks or chain hoist to raise wheels or tracks
off the floor. Always block machine in place
with suitable safety stands
M499
WARNING: When servicing or repairing the
machine. Keep the shop floor and operators
compartment and steps free of oil, water,
grease, tools, etc. Use an oil absorbing
material and or shop cloths as required. Use
safe practices at all times.
M500
WARNING: Some compone nts of this
machine are very heavy. Use suitable lifting
equipment or additional help as instructed in
the Service Manual.
M501
!
!
!
!
!
!
!
WARNING: Engine exhaust fumes can
cause death. If it is necessary to start the
engine in a closed place, remove the exhaust
fumes from the area with an exhaust pipe
extension. Open the door and get outside air
into the area.
M502
WARNING: When the battery electrolyte is
frozen, the battery can explode if (1), you try
to charge the battery, or (2), you try to jump
start and run the engine. To prevent the
battery electrolyte from freezing, try to keep
the battery at full charge. If you do not follow
these instructions, you or others in the area
can be injured.
M503
WARNING: Batteries contain acid and
explosive gas. Explosions can result from
sparks, flames or wrong cable connections.
To connect the jumper cables correctly to the
battery of this machine see the Operators
Manual. Failure to follow these instructions
can cause serious injury or death.
M504
!
!
!