Case IH Farmall 105U Efficient Power, Руководство по обслуживанию

Страница: 41 / 61

Engine - Engine and crankcase
36. - Reassemble the air cleaner assembly and the rele-
vant support, fix the screws on the filter bracket and
on the inlet pipe on the radiator. Refit the sleeves
connected to the turbine, to the engine and to the
cooling fan assembly, tighten the relevant clamps.
Reconnect the pin of the filter clogging sensor.
37. - Refit the two pipes to the radiator intercooler and
tighten the relevant clamps.
38. - Fit the exhaust pipe back on and tighten the relevant
retaining clamps.
39. - Refit the transmission oil drain plug. Refill with oil
using a pump.
40. - Refit the propeller shaft together with the central
support and the fixing screws, insert the shim and
adjust the shaft end float.
41. - Refit the front axle drive shaft guard, tightening the
front, central and rear retaining bolts.
42. - Reposition the fuel drain plug on the tank.
43. - Refit the tank lower guard, if applicable, set the fuel
tank in position and secure it tightening the relevant
retaining clamps. Reconnect the pipes as marked
during disassembly.
44. - Using a hydraulic jack, raise the rear of the tractor,
remove the mechanical stand under the left gearbox,
return the wheel into position and mount the fixing
nuts with a pneumatic gun.
45. - Reconnect the air-conditioning pipes and the sen-
sor to the condenser, fix them with clamps and brack-
ets.
46. - Reconnect the air-conditioning pipes on the com-
pressor and lock them with clamps and brackets.
47. - Recharge the air-conditioning system with refriger-
ant using the specific control unit
380000315 .
48. - Fit the two engine side panels back on and fix the
relevant screws.
49. - Refit the front wheel mudguards, if applicable, and
tighten the relevant fasteners.
50. - Reposition the pack of ballast weights on the rele-
vant support, fit on the cotter pins and the retaining
pin.
51. - Fit the left steps back on, securing them to the cab.
52. - Connect the battery negative lead.
53. - Put the battery cover back on.
54. - Lower the right-hand cab access steps.
55. - Refill the radiator with engine coolant.
56. - Fit the hood back on as described in Hood - Install
(90.100)
84568025 22/03/2013
10.1 [10.001] / 20