Page 2 of 6
ASSEMBLY INSTRUCTIONS (continued)
Installation Steps
2.Install the mounting strap (BB)
to the outlet box with the
stamped word “FRONT” facing
away from the outlet box,
using two mounting screws
(AA) that best fit the outlet box.
Back plate should sit flush
against wall surface when
secured. (Choose one
matching pair of suitable
mounting screws (AA) from
the 3 pairs provided)
Outlet Box
Mounting Bracket
3. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (EE) as follows:
---Connect the black wire from
the fixture to the “hot” wire
from the power source.
(usually black)
---Connect the white wire from
the fixture to the neutral wire
from the power source.
(usually white)
---Connect the grounding wire
from the fixture to the
grounding wire from the
power source. (usually
green / yellow insulation)
Carefully tuck the wires back into the outlet box.
Outlet Box
C
C
A
A
5. Attach the back plate (A)
of the light fixture to the
mounting bracket, secure
it with the fixture
mounting screw (DD).
Push the decorative
cover (CC) firmly into the
fixture mounting screw
hole on the light fixture.
2
1
BB
BB
FF
DD
DD
CC
CC
AA
EE
3
4
4. Place mounting
bracket against the
outlet box, insert the
mounting bracket
screw (FF) through the
mounting bracket hole,
thread mounting bracket
screw (FF) into the center
hole of the mounting
strap (BB). Tighten
the mounting bracket
screw (FF) securely.
▲ When mounting to a
wall, the “UP” arrow
must point upward.
▲ When mounting to an
eave, the “UP” arrow
must point toward the building.
5
Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for
proper operation and to avoid the risk of electrical shock.
For eave mounted only:
Swing the sensor head towards the mounting bracket (A).
Rotate the sensor head (C) clockwise 180˚ so the controls face
down.
Controls
Controls
Controls
Mounting Bracket
1.The fixture mounting bracket is
pre-assembled on the light
fixture. Unscrew both the
decorative cover (CC) and the
fixture mounting screw (DD)
in order to remove the mounting
bracket.
Outlet Box
Mounting Bracket
EE
With silicone caulking compound, caulk completely
around where the mounting bracket meets the wall
surface.
CAUTION: Be sure to caulk completely where the
mounting bracket meets the wall surface to prevent
water from seeping into the outlet box.
