Grill Assembly
STEP EIGHT
13
a. Remove two phillips pan head screws (8A) from the
side burner valve assembly (8B).
b. Carefully insert the valve assembly into the cast side
burner. You will need to angle the tube into the side
burner casting assembly (8C). Make certain that
the elbow is pointing down when the valve is put in
place. Then push the valve stem (8D) out through the
opening in the front of the side burner shelf assembly,
lining up the holes on the valve assembly with the
holes on the side burner shelf.
c. Place bezel (8E) into place, with the "OFF" position
pointing up, making sure to line up holes.
d. Attach bezel & valve to side burner shelf with screws
removed in step 8a.
e. Press knob (8F) onto valve stem assembly.
f. Unscrew the igniter button cap and install AA battery,
negative end in first.
g. Install spring and cap assembly and tighten securely.
h. Insert the four igniter wires fed through the hole on
side of grill head into the remaining three holes.
Note: The igniter is designed in such a way that it does
not matter which terminal tab is used when connecting
igniter wires.
i. Center the brass burner cap (8G) on top of the side
burner head.
j. Place the side burner grate (8H) on to the side burner
tray.Make sure that the three larger legs rest into the
holes in the side burner tray.
8H
8A
8E
8F
8G
8B
8C
8D
