6
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture
need to be burnt off, allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 220-240 Volt , AC electrical outlet only. The
temperature dial must be set at the desired temperature.
Iron does not steam
The water tank may be empty. Turn the steam valve to “ “ and add water. Allow the
iron to heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position.
Iron should be in the horizontal position. Prime pump briefly. Allow a short pause
between shots. Be sure to fully depress the burst of steam button.
Spray mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section “how
to fill the water tank”.
Iron is leaking
The variable steam dial must be set " ",until the iron is hot. The temperature setting is
too low to produce steam. Shot of steam possibly used too much, allow iron to re-heat.
FAQ
