BEFORE FIRST USE
•
Your
CASCADE
appliance has been packaged carefully to
ensure the product reaches you in good condition. If the
product has been damaged, dropped, has a malfunction in
any way, or if the supply cord is damaged, immediately
contact your retailer for replacement or repair.
•
Carefully unpack your
CASCADE
appliance. Make sure you
do not discard any packaging material until all parts of the
appliance have been found.
•
Rinse the inside of the kettle with clean water and discard.
Carefully wipe the exterior of the kettle to remove any dust
that may have accumulated. Dry with a dry towel. Do not
use harsh abrasive cleaners. Remove any label or sticker.
WARNING! Do not immerse in water or any other liquids.
OPERATION
•
Always place the appliance on a level non-slippery stable
surface.
•
Always place the appliance on a heat resistant surface, as
the appliance will reach high temperatures.
•
WARNING
! DO NOT LEAVE ON WHILE UNATTENDED.
•
WARNING
! Always leave a gap of approximately 20 cm
around the exterior of appliance when on. Never use near
curtains, under cupboards or near walls, or other
flammable material.
•
WARNING
!
DO NOT LET SUPPLY CORD HANG OVER
THE EDGE OF ANY BENCH OR TABLETOP. AS THERE
MAY BE A RISK OF SCALDING OR OTHER INJURY
SHOULD YOUNG CHILDREN PULL THE APPLIANCE
FROM THE BENCH OR TABLETOP.
2
•
Plug the power base supply plug into a suitable mains
outlet corresponding to the supply requirements of your
appliance. Mains supply: 220-240V
∼
50Hz – AC only
•
For first time use only:
- Fill the kettle to just below the maximum level
- Place on base and switch on
After this water has boiled and the switch has turned off,
disconnect from power supply, remove kettle from base,
and discard this water. This should eliminate any
impurities in the kettle. Repeat if necessary.
WARNING
! To avoid electrocution, damage to the kettle
or scalding from ejected water, do not over fill or under fill,
do not fill kettle when it is connected to the base or when it
is in operation. Always take special care when moving the
appliance containing hot water. Do not open the lid when
boiling.
•
To switch on depress the on/off switch to position marked
“I”. The indicator lamp will light indicating the kettle is
heating the water.
•
The kettle will automatically switch off and return to
position marked “0” once the water has reached boiling
point.
•
The kettle can be switched off manually at any time. Do not
attempt to re boil water immediately after it has switched
off as this may damage the switch mechanism.
•
Remember to switch off at power supply before removing
kettle from base, before cleaning, or when not in use.
•
CAUTION!
Ensure that the kettle is switched off before
removing it from its stand.
•
CAUTION!
Do not operate the kettle on an inclined
surface. Do not operate the kettle unless the element is
fully immersed. Do not move while it is switched on.
3
