7
R
EVERIE
™
Step 5a. Insert the 12" Permalock pole assembly through
the center of the Decorative Arm assembly, as shown.
Step 5b. Insert the motors wires through the 12" Permalock
pole assembly.
Step 5c Th
read the 12" Permalock downrod into the motor
adapter until it stops turning.
Step 5d. Loosen the four Allen screws (three pre-installed
for the leaf assembly and one for the collar itself in
the bottom of the collar). Insert each of the three Leaf
Assembly pieces into the Leaf Assembly Collar as shown.
Once installed, tighten the Allen screw for each Leaf
Assembly piece to secure into place.
Step 5e Lift the Decorative Arm Assembly to the allow
access to the Allen set screw on the Motor Coupling.
Step 5f. Using the Allen wrench provided, securely tighten
the Allen set screw on the Motor Coupling with to ensure
safe operation of your fan.
Step 5g. Lower the Decorative Arm Assembly back
into place. Tighten both the Decorative Arm Assembly
Collar screw and Leaf Assembly Collar screw to secure,
as shown.
Step 5h. Screw in four 25-watt incandescent lightbulbs in
the sockets on the motor housing.
NOTE: When replacing lightbulbs, be sure to use only
25-watt maximum.
LEAF ASSEMBLY
Decorative Arm Assembly Col-
lar Screw
Motor Wires
(leave at
least 6"
long)
Ground Wire
(green)
Perma•Lock™ Downrod
and Ball Assembly
Tapered Thread
Allen Wrench
Allen
Set Screw
Motor Housing
Assembly
Motor
Coupling
Leaf Assembly
Collar Screw
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and fall
during normal operation.