6
1.7 Operations
Filling The Water Tank:
Manual Fill:
WARNING: Unplug the unit from power source when manually filling the tank.
1. Water can be poured into the unit from the back.
2. Water can be put into the tank through the top opening. There is a hole for water to flow into
the tank.
Continuous Fill:
WARNING: Unplug the unit from power source when servicing.
WARNING: Maximum water inlet pressure 105 p.s.i. / 723 kPa.
1. Unplug the unit from the power.
2.
Connect the garden hose Connector and turn on the water.
3.
Verify water tight connections by visually examining both the float /
hose connections.
4. Turn on the water.
Operating Instructions:
WARNING: Do not operate the unit with pads or grille removed.
1. Fill the water tank manually or after hose connection is made, turn on the water supply to the
cooler.
2. The hose connection to the float valve provides an automatic method of refilling the water
supply as water is evaporated.
3. Whenever possible, operate unit in COOL mode for maximum cooling.
4. When cooling is not required you can operate the unit as a fan only by turning on the fan and
leaving the pump turned off.
5. Plug the unit into 220VAC electrical outlet.
Control Panel:
SPEED / ON OFF
Connect to the power supply and turn the Speed knob. The fan will start. Change the speed from
“1” for Low to “2” for Medium to
“
3” High. To switch OFF the unit turn the Speed knob to "0".
COOL
Turn the Cool knob to ON to start the cooling. It takes a few minutes to obtain the full effect from
this mode.
SWING
Vertical Louvers
Turn the SWING knob to 'ON'. The louvers will begin to move from right to left automatically.
Horizontal Louvers
Manually adjust the horizontal louvers to change vertical airflow.
