SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
B).
When t
he
external
device does not output
signal to terminal
“1” and “3“
,
turn off the relay1 (disconnect terminals B and C, connect terminals A and B).
You can connect external devices (with low level output signal) to terminals
“2”, “3”, the external device’s output signal can control the receiver.
When the external device outputs low level signal to terminal
“2” and “3“, turn on the relay2 (connect terminals B and C, disconnect terminals A and
B).
When t
he
external
device does not output
signal to terminal
“2” and “3“
,
turn off the relay2 (disconnect terminals B and C, connect terminals A and B).
2) The manual switches:
You can connect one manual switch to terminals
“1”, “3”, and then you can use this manual switch to control the receiver.
When connect terminals
“1” and “3”, turn on the relay1 (connect terminals B and C, disconnect terminals A and B).
And when disconnect terminals
“1” and “3”, turn off the relay1 (disconnect terminals B and C, connect terminals A and B).
You can connect one manual switch to terminals
“2”, “3”, and then you can use this manual switch to control the receiver.
When connect terminals
“2” and “3”, turn on the relay2 (connect terminals B and C, disconnect terminals A and B).
And when disconnect terminals
“2” and “3”, turn off the relay2 (disconnect terminals B and C, connect terminals A and B).
How to pair the transmitter to the receiver:
1) Press the button of receiver; signal LED on the receiver keeps shining. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, learning process will be discontinued.
4) The receiver can learn several remote controls with different codes.
Note:
When the receiver enters into status of LEARNING, you should press the button of transmitter that you want to use it to control the receiver. For
example, if you want to control the receiver 1 by pressing button 1 of transmitter, you should press button 1 when the receiver 1 enters into status of
LEARNING.
Delete all transmitters:
We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all stored
codes have been deleted successfully.
