IMPORTANT SAFETY INSTRUCTIONS
4
Do Not Open the Cabinet:
There are no user serviceable components inside this product. Opening the
cabinet may present a shock hazard, and any modification to the product will void your warranty. If water or
any metal object, such as a paper clip, coin, or staple accidentally falls inside the unit, disconnect it from the
AC power source immediately and contact Cary Audio for further instructions.
24.
RECORDING COPYRIGHT:
Recording of copyrighted material for other than personal use is illegal
without permission of the copyright holder.
25.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV system installer's
attention to article 820-40 of the NEC, ANSI/NFPA 70, which provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the grounding system of the building,
as close to the point of cable entry as practical.
26.
FCC INFORMATION FOR USER:
CAUTION:
ANY changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
.
- Connect the equipment into an outlet on a circuit different from where the receiver is connected.
- Consult the dealer or an experienced electronic technician for help.
27.
OUTDOOR ANTENNA INSTALLATION/SAFE ANTENNA
AND CABLE CONNECTION:
If an outside antenna or cable
system is connected to the equipment,
be sure the antenna or cable
system is grounded so as to provide protection against built up static
charges and voltage surges, Section 810 of the national Electrical
Code, ANSI/NFP A70 (in Canada, part 1 of the Canadian Electrical
Code) provides information with respect to proper grounding of the
mast and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding conductors, location of
antenna discharge unit, connection to grounding electrodes and
requirements for the grounding electrode.
Keep Antenna Clear of High Voltage Power Lines or Circuits
An outside antenna system should be located well away from power lines, electric light or power circuits
and where it will never come into contact with these power sources if it should happen to fall. When
installing an outside antenna, extreme care should be taken to avoid touching power lines, circuits or other
power sources as this could be fatal. Because of the hazards involved, antenna installation should be left to a
professional.
