CARVIN ENGINEERING DATA
UX800MC
PG.
3
UX800MC
UX800R RECEIVER FEATURES
»
1. VOL
+
, VOL
-
buttons: Set the output level for the rear XLR and 1/4” output jacks.
»
2. UP, DOWN buttons: When editing settings, use these to increase or decrease the selection.
»
3. POWER button: Press once to turn ON. Hold for 3 seconds to turn OFF.
»
4. MENU button: Allows access to various settings from the display screen.
»
5. IR PORT: Communicates with the transmitter during IR SYNC mode using a low power IR (Infrared) signal.
»
6. ANTENNA CONNECTOR: Carefully thread both included antennas onto the connectors.
»
7. DISPLAY: Backlit LCD display.
UX800R LCD DISPLAY
»
A. GROUP: Displays the selected group setting.
»
B. CHANNEL: Displays the selected channel setting.
»
C. FREQUENCY: Displays the receiving Frequency. Set by the Group and Channel or MASTER mode setting.
»
D. “IR” SYNC: Indicates IR SYNC is selected and ready to match the receiver’s frequency to a transmitter.
»
E. SCAN MODE: Unit is ready to SCAN for an unused channel or frequency.
»
F. LOCK ON: Screen lockout is engaged. No settings can be changed until the lock is turned off.
»
G. MUTE: Displays when the transmitter MUTE function is used, or when output is automatically muted due to lack of RF
signal or Squelch gating.
»
H. ANTENNA INDICATOR: Due to the nature of Diversity reception, the logic circuits continually select between the A or B
antennas for the best signal reception.
»
I. AF METER: The AF meter registers the audio level of the voice or instrument. If the AF meter does not register with
a voice at the microphone, there is a problem with the audio signal being received by the transmitter. Check that the
handheld microphone is turned on, then place the microphone closer to the mouth. If the AF meter shows all 5 bars, the
audio signal to the transmitter is very high and may be distorted. Hold the mic further away from the mouth.
»
J. RF METER: If the RF meter is low or off, the microphone transmitter signal is not being picked up by the receiver.
Be sure the transmitter and receiver frequencies match. If the RF level is still low or fades in and out you may need to
change the frequency channel. Also check placement of the receiver and antennas to make sure they are not close
to metal objects or have loose connections.
UX800R
3
7
4
2
5
6
1
6
E
C
I
J
G
A
B
F
H
MASTER
5
1
2
3
6
SWITCH
D
3,4
UX800R
3
7
4
2
5
6
1
6
E
C
I
J
G
A
B
F
H
MASTER
5
1
2
3
6
SWITCH
D
3,4