CARVIN ENGINEERING DATA
CARVIN ENGINEERING DATA
UX800MC
PG.
2
INTRODUCTION
Congratulations on your purchase of the
UX800 Professional 400 Channel Wireless
System. The UX800R receiver is loaded
with features including diversity antennas
and IR SYNC to easily select frequencies.
The clear, backlit LCD screen displays
channel frequency information (use up to
8 systems simultaneously), AF, RF meters,
lock mode which prevents accidental
changes and mute. The UX800MCH
handheld mic is rechargeable with the
optional UX800C Dual Mic Charging Base
and includes 3 mode power on/off settings
to prevent accidental turn offs and rugged
construction with anodized aluminum
housing. Natural vocal reproduction delivers
superb performance without distortion or
feedback.
GETTING STARTED QUICKLY
If you’re like most new owners, you’re probably in a hurry to use your wireless system. To start, you must have the
UX800MC, an XLR or 1/4” cable, and a sound system to hear the signal through.
»
1. TRANSMITTER CONNECTIONS: Insert 2 fresh AA alkaline batteries or NiMH rechargeable AA batteries into
the handheld microphone transmitter.
BATTERIES NOT INCLUDED.
»
2. RECEIVER CONNECTIONS: Attach both antennas at the ANT.A and ANT.B connectors by carefully threading
them on. Connect the AC adapter to the receiver, then plug it into AC power. Use an XLR cable or
shielded 1/4-inch cable to connect one of the outputs to your sound system.
»
3. RECEIVER POWER ON: Turn down the VOLUME of the receiver and the system it is connected to. On the
front right of the receiver, press the POWER button until the display lights up.
(HOLD the POWER button 3
seconds to turn OFF)
.
»
4. TRANSMITTER POWER ON: Slide the switch on the handheld microphone transmitter to the up position. The
LCD display will turn on, then shuts off after a short time.
»
5. CHANNEL SET: The transmitter and receiver must have the same Group and Channel settings (Frequency)
to work. The
IR SYNC
feature makes this easy- use the IR SYNC feature to match the channel on both
transmitter and receiver:
On the receiver, press the MENU button 4 times until “IR” is displayed on the top
line of the display
. Hold the transmitter so the handheld microphone display points toward the receiver at the
white circle with “IR.))))” below it. On the receiver, press the UP button to start the sync while holding the
transmitter in place until the sync is complete and “IR” is no longer lit in the display. If using multiple systems,
each transmitter/receiver pair must be set to a different group/channel setting. Read further for manual
settings.
»
6. SOUND CHECK: On the UX800MC receiver, use the VOL+/VOL- buttons to start with a low level. Use the mic
as intended and gradually raise the output levels on the sound system to a comfortable volume.
UX800R
UX800MCH