SUSPENSION
About the SlideLockTBAR™:
The SlideLockTBAR™ provides a hang
point to suspend up to four VELA™
cabinets inline from a 5/8” shackle and
standard rigging such as a chain hoist.
The hang angle can be adjusted depend-
ing on the chioce of shackle attach point.
Connecting the SlideLockTBAR:
1.
SLIDE
the
SlideLockTBAR
into the
SlideLock
™
plates on the top of the VELA.
The TBAR should extend about 3.5 in.
(90mm) off the rear of the VELA cabinet.
2.
SECURE
the SlideLockTBAR with the
two quick release pins: Line up the holes
in the top rear of the VELA hardware
with the holes in the SlideLockTBAR
hardware. Insert the two pins as shown.
Pressing the button on the end of the pin
allows the pin to slide in or out.
3.
ADD MORE VELA
cabinets to the
bottom of the first, securing each one
with two quick release pins as they are
attached (see the STACKING procedure).
If more that two VELA are attached, use
the chain hoist to lift them up to the proper
level for attaching. The maximum number
to safely hang inline is 4 cabinets.
4.
SET THE ANGLE
of the hang by
selecting a different shackle location. The
fourth hole from the front will be a vertical
hang. Attaching the shackle to the rear will
tilt the hang down. Attaching the shackle
to the front will tilt the hang upward.
Add SlidelockTBAR
™
for flying and
secure with the quick release pins
Tilt down
Tilt up
