CARVIN
®
PLATINUM SERIES OVAL POOL | USER MANUAL
7
3/4’’ (19mm) HEX SOCKET
P/N 14455035
Max torque 66 N·m (49 ft·lbf)
P/N 14455095
STEP 2
Insert the sleeve (46025010) into the footbeam channel and then insert a ½ bolt
(14455035) with washer (14455095) and then put a washer on the other side and a
screw nut (14455045). Repeat for the other bottom bolt. For the upper sleeve of the
buttrest post you will require to assemble 2x2 washers on each sides of the sleeve,
inside the post. Insert the polystyrene block at each end. Tighten bolts at 66 N·m (49
ft·lbf).
UNPACKING THE POOL PARTS
Open all the boxes that were supplied with your pool. Layout on the ground all the
parts and make sure that you have all the parts listed in the BOM section at page
23. Make sure that you DO NOT start installation if any parts are missing. Contact
your seller if that is the case, he will provide the missing parts. Make sure to inspect
if there are any defects in the parts before installation. Do not untie and unroll the
pool wall before
Assemble the round section rails
, as it will be harder to install.
ASSEMBLING THE FOOTBEAM AND BUTTREST POSTS
For this assembly you will need the following parts ready (Qty shown for 1 post).
STEP 1
Assemble the buttrest (46025009) post on top of the footbeam (46025008) aligning
the holes.
