CARVIN
®
DIAMOND SERIES OVAL POOL | USER MANUAL
18
STEP 5
When water reaches 4” (10 cm) deep, turn o
ff
the vacuum and remove the vacuum hose.
Skimmer
Water return outlet
Remove the hose
4’’
STEP 6
When water reaches 12” (30 cm) deep, you may use a faster water
fl
ow supply.
STEP 7
When water reaches 24” (60 cm) deep, the liner should have stretched properly. Cut
the liner holes for the water return and the skimmer opening.
STEP 8
STEP 9
Complete the
fi
lling of the pool until the water reaches 1.5’’ to 2” below the top of
the skimmer.
STEP 10
You may now power up your circulation and
fi
ltration system. Make sure to use and
maintain those equipment as recommended by their respective manufacturers.
INSPECTION
The parts most likely to cause a leakage problem are the skimmer and the water
return. Regularly inspect those areas of these two components to make sure there is
no water leakage on the wall of the pool. Make the necessary repairs to the
protection joints of the skimmer and water return (see replacement of these parts)
to stop any leakage as it may cause rust and seriously damage the pool wall, the
bursting of the pool that could cause signi
fi
cant damage to your property and/or
your neighbors.
Your pool liner must be inspected regularly for leaks. Also, inspect your wall for
corrosion and scratches. If problems are detected,
action must be taken immedi-
ately.
Small leaks or holes in the liner can be repaired easily using repair kits sold
at your dealer. Corrosion and scratches on the pool wall must be repaired by using
an anti-rust enameling product. Rub the rusted surface with a wire brush, apply the
anti-rust product and repaint the wall to match the repair to the color of the wall.
Install your circulation and
fi
ltration system, including the following minimum
equipment:
• A skimmer
• Pool pump
• Filter
• Water return
Make sure to use and maintain those equipment as recommended in their respective
manufacturers. Do not power up the equipment at this point. If the water reaches
2” bellow the water return and the above equipment is not installed, stop
fi
lling the
pool.
Skimmer
Water return outlet
2’’
Neglecting maintenance of your pool will void the
warranty of your pool
To allow natural expansion of the pool, the
fl
ow rate at
fi
lling should not exceed 16 GPM. not to make any back-
fi
ll around the swimming pool before it is completely full
of
water
A basic circulation and
fi
ltration system
MUST BE INSTALLED on your pool.
Make sure you follow all local and provincial regulations
when you proceed with pool accessories installation.
The components allowing entry into the pool must be
approved for the safety of users.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
1.75’’
