Carver Pump RSV Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 14 / 90

RSV Series
–
In-Line Vertical Multi-Stage, Ring Section Pump December 2016
7
Table 3. Recommended Coupling Bolt Torque Values (ft-lbs)
Drawing Reference
120-5 120-6
Model Bolt Size Specification Bolt Size Specification
RSV3
M6 6 ft-lbs 8.5 N-m M6 6 ft-lbs 8.5 N-m
RSV5
RSV10 2
–
RSV10 3 M6 6 ft-lbs 8.5 N-m M6 6 ft-lbs 8.5 N-m
RSV10 4
–
RSV10 12 M8 15 ft-lbs 20 N-m
RSV10 13
–
RSV10 16 M10 30 ft-lbs 40 N-m
RSV18 2 M6 6 ft-lbs 8.5 N-m M6 6 ft-lbs 8.5 N-m
RSV18 3
–
RSV18 5 M8 15 ft-lbs 20 N-m
RSV18 6
–
RSV18 11 M10 30 ft-lbs 40 N-m
RSV32 1 M6 6 ft-lbs 8.5 N-m M6 6 ft-lbs 8.5 N-m
RSV32 2-2
–
RSV32 3-2 M8 15 ft-lbs 20 N-m
RSV32 3
–
RSV32 10-1 M10 30 ft-lbs 40 N-m M12 50 ft-lbs 68 N-m
RSV45 1-1
–
RSV45 1 M8 15 ft-lbs 20 N-m
RSV45 2-1
–
RSV 45 7-2 M10 30 ft-lbs 40 N-m M12 50 ft-lbs 68 N-m
RSV64 1-1 M8 15 ft-lbs 20 N-m
RSV64 1-0
–
RSV64 4-0 M10 30 ft-lbs 40 N-m M12 50 ft-lbs 68 N-m
VI. SERVICE AND REPAIR.
For service and repair for each specific RSV model,
please refer to Section as indicated in Table 4.
A. MOTOR INSTALLATION ON BARE PUMP.
WARNING
When lifting the pump/motor, use appropriate
crane (or hoist), check position and tightness of
lift system so that weight of the pump is not
unbalanced. Failure to observe this precaution
can result in serious accidents.
A.1 Procedure for mounting motors for the
following models:

RSV3 2
–
RSV3 12

RSV5 2
–
RSV5 6

RSV32 1

RSV10 2
–
RSV10 3

RSV18 2
WARNING
Before attempting to disassemble the pump,
the electrical power supply to the driver must
be locked and tagged in the “OFF” position to
prevent injury or death to personnel servicing
the pumping unit.
1. Follow general safety and electrical instructions
on the motor nameplate.
2. Remove coupling guard from the pump end.
3. Carefully loosen the screws on the coupling.
4. Position the motor vertically over the pump with
the keyways lined up on the motor and the
pump. Then lower the motor into place. If
necessary rotate the motor so that the mounting
bolt holes line up with the corresponding holes
in the pump bracket.