WARNING! The lens and the
light bulb on the built-in work
light could heat to approx.
60 C during and after operation,
possibly resulting in minor burns when
touched with delicate areas of the skin!
Image 8
▪
Push the housing frame near where it
connects to the housing (see arrow
Image 8) toward the bulb and remove
the connector.
▪
Then remove the frame and the clear
work light lens , unscrew the bulb
(12 V, 3.6 Watt) and replace with a
new bulb.
▪
Replace the clear lens and reconnect
the work light frame with the unit
housing so it locks into place.
Image 7
°
▪
Be sure the external device is suitable
for operation with a 12 V power
source with a maximum load of 10 A.
Also refer to the manual for the ex-
ternal device!
▪
Verify the external device is switched
off.
▪
Remove the cover from the 12 V
car outlet .
▪
Insert the external device's 12 V car
plug into the unit's 12 V car outlet
(see Image 7).
▪
Switch on the external device.
▪
The operating time of the external
device depends on its power con-
sumption and the charge of the
storage battery.
▪
After using the external device unplug
the 12 V car adapter from the unit's
12 V car outlet.
▪
Then insert the cover all the way
into the opening of the 12 V car outlet
.
The 12 V car outlet located on the
side of the unit may be used as a 12 V
power source for suitable external de-
vices. The socket is always operational.
The load may be a maximum of 10 A.
DE
21
20
21
20
21
21
8
34
Power Station
4.4.2 Charging by 12 V car charger
4.5 Using the unit´s 12 V car outlet
4.4.2 Charging by 12 V car charger
4.6 Replacing the work light bulb
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:38
