Cartrend 10728, Инструкция по эксплуатации

Страница: 24 / 104

24
12 V Portable Compressor
Checking the tyre pressure
Note:
the display [11] must read 0.0 before measuring.
1. release the lever on the valve adapter [7].
2. attach the valve adapter [7] to the valve on the vehicle and
secure.
If the valve adapter [7] is correctly connected to the vehicle’s
valve, the display [11] will show the current tyre pressure.
3. If this value corresponds to the recommended tyre pressure for
the vehicle you can remove the valve adapter [7].
Increasing the tyre pressure
Important:
• Do not press the buttons [12] or [14] whilst inflating.
• release the On/Off switch [5] to manually stop inflating.
• If the device is connected to the vehicle’s 12 V power supply but
you do not start inflating, the display [11] will switch off after a few
minutes. It can be reactivated by pressing the pressure unit button
"uNIt" [13].
If the value shown is below the vehicle’s recommended tyre pres-
sure, proceed as follows to adjust it:
4. Press the preset button "+" [12] or preset "-" button [14] for 2-3
seconds until the value in the display flashes.
5. Press the "+" [12] or "–" [14] buttons until the preset in the dis-
play [11] corresponds to the correct tyre pressure.
6. Press the On/Off switch [5] to switch the compressor on. the
compressor increases the tyre pressure according to the preset
value and switches off automatically.
7. release the lever on the valve adapter [7] and carefully discon-
nect the valve adapter [7].