Cartoni MASTER 65 FLUID HEAD, Руководство пользователя

Страница: 7 / 9

5
3. Procedures

Open the tripod to the desired height and lock all the knobs.

Place the MASTER 65 head on tripod base and rotate until it matches the steel notch;
tighten the head firmly screwing in the knob (12) underneath the flat base. Check the
spirit bubble (22) and modify the legs angle if needed. In case of low visibility, press
button (21) for bubble light and to activate the digital displays. Light will turn off
automatically after approximately 30 seconds.

Lock horizontal position with button (8), insert pan lock (11) and turn both tilt drag
selector (23) and counterbalance selector (19) to position “0”.

To release the camera plate (1) slide forward the camera plate lock lever (5) and rotate
it 90° counterclockwise, then remove the camera plate.

Attach the camera plate to the bottom of the camera assembly and firmly secure it
with both screws. Try to place the camera plate centered under the camera system,
keeping in mind the position of the center of gravity.

Place the camera on the top of the MASTER 65, pushing the camera plate (1) forward
to perfectly match the sliding plate seat, then close the camera plate lock lever (5).

Holding the pan bar (17) firmly, disengage horizontal lock with button (9) and find the
correct center of gravity sliding the camera assembly fore and aft using the sliding
crank (16) (extract the knob to rotate). Lock the slide with lever (13).

Set the counterbalance system by turning the counterbalance selector (19) to
appropriate tension. The camera has to stay still at any tilt angle. If needed, fine tune
balance, adjusting the sliding plate.

Push button (21) to activate displays (20), unlock pan lock (11) and select the desired
fluid drag intensity on both pan and tilt by turning pan selector (18) and tilt selector
(23).