Carson X-18 Pro, Инструкция по эксплуатации, Страница: 26 / 56

26
GB
CARSON X-18 Chassis 500 500404047
Program the ESC
1. Programmable items
(the italics texts in the form are the
default settings)
2. Explanation for each programmable item
Running mode
With “Forward with Brake” mode, the car can go forward and brake,
but cannot go backward, this mode is suitable for competition.
“Forward/reverse with brake” mode provides backward function,
which is suitable for daily training.
But for ESC, “Forward/reverse with brake” mode uses the “Single-
click” method to make the car go backward.
“Forward/reverse” mode uses the “Single-click” method to make the
car go backward. When you move the throttle lever from forward
zone to backward zone, the car will go backward immediately.
Drag brake force in neutral position (throttle)
Set the amount of drag brake applied at neutral throttle to simulate
the slight braking effect of a neutral brushed motor while idle speed.
2.1. Low voltage cut-off
The function prevents the lithium battery pack from over discharging.
The ESC detects the battery’s voltage at any time. If the voltage is
lower than the threshold for 2 seconds, the output power will be
reduced 70%, 10 seconds later the output will be completely
stopped, and the red LED flashes in such a style: “
✼ ✼
,
✼ ✼
,
✼ ✼
”
(double flashes).
2.2. Acceleration mode (also called “Punch”)
Select from “Level 1” to “Level 4”. A higher number means more
aggressive acceleration.
3. Program the ESC with the “SET” button
You’ll find the instructions on the next page in the flowchart.
4. Reset all items to default values
At any time when the throttle is located in neutral zone (except in the
throttle calibration process or ESC program mode), you can hold the
“SET” key for over 3 seconds. The red LED and green LED will flash at
the same time, which means each programmable item has be reset to
its default value.
Programmable items for Dragster Micro Brushless
Programmable
item Programmable
value
1 2 3 4 5 6 7 8
1. Running mode Forward with brake Vorwärts/
Rückwärts mit
Bremse
2. Drag brake force
in neutral position
0% 5% 10% 15% 20% 25% 30% 40%
3. Low voltage
cut-off
threshold
Non-protection 2.6 V/cell 2.8 V/cell 3.0 V/cell 3.2 V/cell 3.4 V/cell
4. Start mode (punch) Level 1 Level 2 Level 3 Level 4
5. Maximal
brake
force
25% 50% 75% 100%