
GB
33
CARSON DRAGSTER Brushless Controller
When the battery type is selected, the undervoltage protection (NiCd/
NiMH: at 4 V or lower, two or three-cell LiPo: at 3.0 V per cell or lower) is
activated.
If you wish to drive without undervoltage protection (Cut-Off), you must
select 5 in the driver profile (reset to factory defaults) and reconfigure the
other parameters to your requirements again.
Flashing
frequency
1
2
3
Battery type
NiCd/NiMH
LiPo
(2 cells)
LiPo
(3 cells)
• Switch on the transmitter, then the controller!
• Press the SET button down until the red LED lights up. Release the SET
button.
• The red LED starts flashing. This shows that you are in the mode for
setting the battery type.
• Press the SET button again briefly. This brings you to the next setting.
The red LED flashes at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the
SET button for more than
10 seconds the controller
reverts to the last setting
and is ready for use again.
8. Selecting the Battery Type
Содержание Dragster Sport
