Carson 500507049, Инструкция по эксплуатации

Страница: 22 / 40

GB
// 22
Trimming the quadcopter
Already shortly before the quadcopter takes off, you can recognize
whether it wants to turn or glide in a particular direction. Correct
the deviations from the vertical ascent with the trim knob of the
turn function.
Tip of the fuselage turns to the right:
• Reduce speed and push the trim slider of the turn function on
the left remote control lever stepwise to the left.
• Push the pitch-lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to
the left.
• Repeat the process until the quadcopter no longer shows a
tendency to turn to the right.
Tip of the fuselage turns to the left:
• Proceed as described above, but push the trim slider of the turn
function stepwise to the right.
FLIGHT OPERATION
Blade A Blade B
Problem Cause Reparation
The model does not move Check, if the transmitter and the model are
switched ON.
Switch on the Transmitter and the Model.
Check the battery voltage of transmitter
and model
Employ completely charged batteries
Motor does not turn Motor is defective Exchange the motor
Motor is too hot Allow the motor to cool down
The model reacts incorrectly to the con-
trol commands or flies choppily
Check the state of the transmitter and
receiver battery charges
Employ completely charged batteries
The model does not take off Rotor blades are twisted Exchange the rotor blades
Motor is too hot Allow the motor to cool down
Batteries are empty Charge the batteries or exchange them
The model moves forward/ backward and
sidewise, but does not hover
Check whether the Helicopter is exposed to
a draught, e.g. by an opened window or an
air conditioner. Hover flight is not possible
when there is a draught
Close the window/door, switch off the air
conditioner or select a more suitable room
The model vibrates severely
Check whether the rotors run true Possibly change the rotor blades
Transmitter and Helicopter can not be
binded
Throttle control not set to minimum Throttle need to be minimized to zero
Can not take off Wrong installation on rotors Mount the propeller as shown below
TROUBLESHOOTING