Carson 500108008, Инструкция по эксплуатации

Страница: 21 / 24

21
Problem Cause Remedy
Model does not move
Switch(es) on transmitter or/and model is/
are “off” Switch on
Weak or no battery in the model Insert fully charged battery
The overheat cut-out has stopped the model
due to overheating Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
No control
Weak rechargeable battery/battery in trans-
mitter or model Insert fully charged battery or new battery
You pull the throttle backwards for
forward drive as described in the instruc-
tions, but the model moves backwards.
The connecting cables between the speed
controller and the motor are not correctly
connected. Swap 2 of 3 connecting cables between the
motor and the controller.
The channel changeover switch on the trans-
mitter is wrongly set. Set the channel changeover switch in the
opposite direction to "Reverse" or "Normal".
The brushless motor suddenly stops
during normal operation.
The receiver is being affected by interference. Change location and start operation in ano-
ther area.
The functions of the speed controller have
been stopped by the integrated safety shut-
off for low battery voltage or overheating. Replace the driving battery with a fully char-
ged battery or wait until the electronics have
cooled down.