CarShow Installation Guide - Toyota Tundra/Sequoia
CarShow
Copyright 2013 All Rights Reserved
Installation Guide
CS-TUND09-3
Page 5
Faceplate/ECU Alignment
Verify faceplate bracket screw holes are aligned to
ECU mounting screw holes.
Make sure 28-pin connector is tucked completely
inside faceplate cavity as shown at right
Mounting Screws
Verify faceplate bracket screw holes are aligned to
ECU mounting screw holes.
Be sure that all 4 (2 left/ 2 right) Phillips screws are
screwed in tightly to avoid damage to faceplate/ECU.
Mounting Screw Verification
Be sure that all 4 (2 left/ 2 right) Phillips screws are
screwed in tightly to avoid damage to faceplate/ECU.
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.
And mount the iPod Interface Connector in the vehicle. The following steps will help guide you through
this process.
STEP
4
Use Caution around SRS Components
I
t is the
installer’s responsibility
to ensure that the safety
equipment in the vehicle is
NOT
adversely affected by
installation of this system. Ensure that the routing of the
harnesses do NOT obstruct airbags, SRS or other safety
devices.