CarShow Installation Guide - Toyota Prius
CarShow
Copyright 2013 All Rights Reserved
Installation Guide
CS-PRIS12-3
Page 5
28-Pin Connector
Be sure that 28-pin connector is securely connected
PRIOR
to securing faceplate to ECU.
NOTE:
If faceplate connector is not fully connected to
ECU, system will display
“No Faceplate Detected”
in
the top Nav bar of the menu screen when unit is
powered on.
Faceplate/ECU Alignment
Verify faceplate bracket screw holes are aligned to
ECU mounting screw holes.
Make sure 28-pin connector is tucked completely
inside faceplate cavity as shown at right
Mounting Screws
Verify faceplate bracket screw holes are aligned to
ECU mounting screw holes.
Be sure that all 4 (2 left/ 2 right) Phillips screws are
screwed in tightly to avoid damage to faceplate/ECU.
Mounting Screw Verification
Be sure that all 4 (2 left/ 2 right) Phillips screws are
screwed in tightly to avoid damage to faceplate/ECU.
