CarShow Installation Guide
CarShow
Copyright 2012 All Rights Reserved
Multi-Media Navigation System Installation Guide
CS-GM1014
Page 7
Connect the Power and GPS Harnesses
The GPS Antenna Harness must be tightened with a
WRENCH
to ensure it is properly seated.
Be sure to use white cable clamp to secure GPS antenna cable
Failure to follow this step may result in poor GPS signal
Connect Optional Harnesses such as iPod,
Satellite Radio, Camera, Reverse Sensors
These harnesses must be fully engaged prior to the system
installation.
See the Harness Diagrams for more information
Prepare the Vehicle side harnesses for
connection to the Car Show Harness
Use care not to pinch or damage cables as this will cause
performance issues/failures
Engage all Connectors to the Factory
Harnesses
Use the previously removed Mounting Bolts to
secure the Car Show System
If the unit does not fit FLUSH, check the cables for
clearance, DO NOT FORCE the unit in.
Re-install Dash Trim
Re-Install dash trim using caution.
Be sure that all vehicle connectors (Climate control, Hazard
lights etc…) have all been reconnected
PRIOR
to starting
vehicle!
Turn the vehicle ON and confirm the unit is
fully operational
With the connectors
Fully Engaged
, turn the vehicle on
and press the
RESET
for 5 seconds on the unit.
CAUTION
CAUTION