CarShow Installation Guide
CarShow
Copyright 2012 All Rights Reserved
Multi-Media Navigation System Installation Guide
CS-GM1014
Page 2
Identify the Vehicle Audio System
The first step you need to complete
Is to CONFIRM the Vehicle Audio System before you proceed. The Car Show Nav Systems
are specifically designed to be CONFIGURED to work in appropriate vehicles.
STEP
1a
This System can be Configured to work in
ALL Audio Platforms
Using the wrong Configuration will cause
various audio performance problems
See the Trouble Shooting at the end of this Install Guide for symptoms
SOME VEHICLES ARE NON-AMP
These are typically the very low-end vehicles and work trucks.
They will not have any BOSE logos on the vehicle
CONFIGURE THIS WAY
USE HARNESS: DP-GM1016
INSTALLER SETTING MENU: CENTER PT =
OFF
MOST VEHICLES ARE STD-AMP
These are typically the mid-range vehicles
. They may have any BOSE logos on the vehicle
CONFIGURE THIS WAY
USE HARNESS: DP-GM1012
INSTALLER SETTING MENU: CENTER PT =
OFF
FEW VEHICLES ARE CENTERPOINT
These are the high-end vehicles including all GMC
Yukon/Sierra Denalis.
They may have BOSE logos on the vehicle
NOTE: CS-GM1010 IS
NOT
COMPATIBLE
WITH BOSE CENTERPOINT EQUIPPED
VEHICLES.
STILL NOT SURE…???
Go To STEP 1b
Check the Vehicle RPO Codes
as shown on the next page