Carrier XCT7 40VCW217FQEE, Инструкция по установке и эксплуатации

Страница: 11 / 126

B
(Evade): Swing direction Evades people.
B
(Evade): Swing direction Evades people.
(Perception): If no one is perceived for half an hour (the time depends on the indoor unit or the setting of
move eye), the indoor unit will be off.
(2) Press MENU key, you will enter function cycle, use or key to switch between different functions. Switch to
A
/
B
/ function, then press MENU key again,
A
/
B
/ function will be turned on. If the
function is turned on,
A
,
B
and icon will be displayed in the main interface. In the state where the
A
/
B
/ function is turned on, and you want to turn it off, please enter function cycle and switch to
A
/
B
/ icon, then press MENU key, to turn off the function.
(3) When the
A
/
B
function is turned on, if you adjust swing angle, the
A
/
B
function will be turned
off.
(4)
A
/
B
/ functions cannot be turned on at the same time. Only one function can exist at a time.
Mode setting (applicable for some models)
(1) When controller is turned off, and the backlight is lit up, long press MODE key for 5 seconds to enter mode
setting interface. The parameter is displayed in the top-left corner, and you can use or key to switch it
between 00/01/02/03/04/06/07. After adjustment, you need to press MENU key to confirm changes.
(2) The correspondence between parameters and mode combinations is shown below:
00------------ [Auto] [Cooling] [Dry] [Fan] [Heating]
01------------ [Heating] [Cooling] [Dry] [Fan]
02------------ [Fan] [Cooling] [Dry]
03------------ [Heating] [Cooling] [Dry] [Fan]
04------------ [Fan] [Heating] [Cooling]
06------------ [Heating] [Fan]
07------------ [Heating]
(04/06/07 is valid under the third edition communication protocol)
(3) Fresh Air unit can execute mode setting. It will execute the three modes of Fresh Air unit (cooling/ heating/fan
mode).
Note:
This function requires indoor unit support. If the indoor unit does not support it, you may not be able to set it.
Malfunction Display
(1) If there is a malfunction, the main interface will display icon.
(2) When backlight is on, long press TIME key for 10 seconds to enter malfunction display interface. The malfunction
code is displayed in the top-left corner, and the left side of the colon is the current malfunction, and the right side
of the colon is the historical malfunction. And you can also press TIME key to view more historical malfunction
information. The lower right corner shows the unit number. You can use or key to switch it (if the controller
controls multiple units).
(3) While viewing malfunction, long press TIME key for 10 seconds to clear the current malfunction and a historical
malfunction.
(4) If there is no malfunction, the display will be “- -”.
Operation
9