Carrier Taylor 632, Руководство по эксплуатации

Страница: 21 / 50

17
Model 632 Operating Procedures
Slide the two o--rings into the grooves on the prime
plug. Apply an even coat of Taylor Lube to the o--rings
and shaft.
Figure 8
Insert the prime plug into the hole in the top of the
freezer door, and push down.
Figure 9
Step 4
Install the freezer door. Insert the baffle rod through the
opening in the beater and seat the door flush with the
freezing cylinder. With the door seated on the freezer
studs, install the handscrews. Tighten equally in a
crisscross pattern to insure the door is snug.
Figure 10
Step 5
Install the draw valve. Slide the two o--rings into the
grooves on the draw valve, and lubricate.
Figure 11
Lubricate the inside of the freezer door spout, top and
bottom, and insert the draw valve from the bottom
until the slot in the draw valve comes into view.
Figure 12
Step 6
Install the adjustable draw handle. Slide the o--ring into
the groove on the pivot pin, and lubricate.
Figure 13