Carrier PC-09HPPD PD Portable, Инструкция по эксплуатации

Страница: 10 / 16

4. OPERATION
4.2 OPERATION
7 GB-9
Press
MODE
and select ;
NOTE:
In this setting the system will automatically change modes and fan speed to the set temperature.
In spring and autumn, closer temperature control may require
COOL/HEAT
mode changes.
Fan speed and temperature can not be adjusted under
AUTO
mode.
The louver can only be adjusted when the unit is switched on.
Press
SWING
to initiate auto-swing. Press
SWING
again to stop the louver from swinging.
AUTO Mode
SWING FUNCTION
Basic Operation Modes
： COOL / DRY / HEAT / FAN / AUTO
1) Press
MODE
and select ;
2) Press
+/-
on the unit or
TEMP
on the remote control to select the temperature.
3) Press
FAN
on the unit or remote control to select the fan speed.
COOL Mode
1) Connect the drain hose as figure shown.
2) Press
MODE
and select ;
NOTE:
Please remove the exhaust hose before
DRY
operation.
Fan speed and temperature can not be adjusted under
DRY
mode.
When stop the
DRY
operation, make sure all water is drained before removing
the drain tube and inserting the drain outlet plug onto the back of unit.
DRY Mode
Under DRY Operation
1) Connect the drain hose as figure shown (different drain port from that of
DRY
mode).
2) Press
MODE
and select ;
3) Press
+/-
on the unit or
TEMP
on the remote control to select the temperature.
4) Press
FAN
on the unit or remote control to select the fan speed.
HEAT Mode
1) Press
MODE
and select ;
2) Press
FAN
on the unit or remort control to select the fan speed.
NOTE:
Temperature can not be adjusted under
FAN
mode.
FAN Mode
Under HEAT Operation
Special Functions
NOTE:
Do not adjuct the louver manually.
Auto ON/OFF time can be set by control panel or remote controller.
On control panel:
When the unit is switched on:
1) Press
TIMER
. The
OFF
will be illuminated.
2) Set the auto off time by pressing
+/-
. Press
TIMER
to confirm. Then the
ON
will be illuminated.
3) Set the auto on time by pressing
+/-
. Press
TIMER
to confirm. Both
ON/OFF
will be illuminated. The unit is now programmed
to auto on/off.
When the unit is switched off:
1) Press
TIMER
. The
ON
will be illuminated.
2) Set the auto on time by pressing
+/-
. Press
TIMER
to confirm. Then the
OFF
will be illuminated.
3) Set the auto off time by pressing
+/-
. Press
TIMER
to confirm. Both
ON/OFF
will be illuminated. The unit is now programmed
to auto on/off.
NOTE:
To set the
TIMER
function with remote controller, please refer to instruction in remoter controller manual.
To cancel the auto on/off time setting, press the
ON/OFF
button, or set the timer to 0,0.
TIMER FUNCTION