32802000301
9
Specifications subject to change without notice.
Sleep Mode
SLEEP mode is used to conserve energy and can be used when the unit
is in the COOL, HEAT or AUTO mode only.
Cool Mode
a. Push SLEEP. After 1 hour the set point raises by 1.8
_
F (1
_
C).
After another hour, the set point raises by another 1.8
_
F (1
_
C)
and the fan runs in a low speed. The unit shuts off 5 hours after
setting the SLEEP mode. The SLEEP mode cancels if either
MODE, TEMP, FAN, TIMER, or ON/OFF on the remote
control are pressed.
Heat Mode
Same as cooling mode however set points are lowered by 1.8
_
F (1
_
C).
Turbo Mode
Use the TURBO mode to cool or heat the room rapidly.
a. Press TURBO. An audible “beep” is heard if the indoor unit
supports this function. The fan runs on super high speed. The
TURBO mode terminates automatically 20 minutes after
pushing TURBO. It can be terminated immediately by
selecting TURBO again. When the TURBO mode is
terminated, the unit reverts to the original setting.
Self Clean Mode
Press CLEAN to activate or deactivate the self−cleaning function.
Under this function, the air conditioner automatically cleans and dries
the evaporator. The cleaning cycle takes 16 minutes, after which the
unit turns off automatically. Pressing CLEAN in the middle of the
cycle cancels the operation and turns off the unit. This function can be
activated only in the COOL or DRY mode.
Follow Me Mode
Press Follow Me to activate or deactivate this function. Under this
setting, the temperature that appears in the remote control is the
actual temperature at its location. The remote control sends this
signal to the air conditioner every 3 minutes. This function is not
available for DRY and FAN modes.
Freeze Protection Mode
Press FP for approximately 2 seconds to activate or deactivate the
freeze protection mode (heating set back). The indoor unit displays
“FP”.
NOTE: This function is only available in the heating mode.
Under this function, the unit operates at high fan speed and the coil
temperature automatically sets to 46
_
F (8
_
C). This mode can also be
deactivated by pressing ON/OFF, SLEEP, MODE, FAN, or either
TEMP.
Silence Mode
NOTE: The Silence Mode (SLC) feature is not available on this
model.
LED Light
Press LED to turn the display light on and off.
Resetting the Remote Control
If the batteries in the remote control are removed, the current settings
will be cancelled and the control returns to the initial settings and will
be in standby mode. Push ON/OFF to activate.
Time Delay
If ON/OFF is pressed too soon after a stop, the compressor will not
start for 3 to 4 minutes due to the inherent protection against
frequent compressor cycling. The unit only emits an audible beep
when the signals are received correctly.
Heating Features
If the unit is in the heating mode, there is a delay when the fan starts.
The fan starts only after the coil is warmed up to prevent cold blow.
Auto Defrost Operation
In HEATING mode, if the outdoor coil is frosted, the indoor fan
and outdoor fan turns off while the system removes the frost from
the outdoor coil. The system automatically reverts to normal
operation when frost is removed from the outdoor unit.
Auto Start
If the power fails while the unit is operating, the unit stores the
operating condition, and the unit will start operation automatically
under those conditions when the power is restored.
