32802000301
7
Specifications subject to change without notice.
Cooling /Heating/Fan Operation
Ensure the unit is plugged in and power is available.
1. Press the MODE button to select COOL, HEAT (cooling and
heating models only), or FAN mode.
2. Press the UP/DOWN buttons to set the desired temperature. The
temperature can be set within a range of 62
°
F~86
°
F in 1
°
F
increments.
3. Press the FAN button to select the fan speed in four steps− Auto,
Low, Med, or High.
4. Press the ON/OFF button to start the unit.
NOTE: In FAN mode, the setting temperature is not displayed on the
remote controller and you are not able to control the room temperature.
In this case, only steps 1, 3, and 4 may be performed.
DEHUMIDIFYING OPERATION
Fig. 11
-
Remote Controller Buttons for Dehumidifying Opera-
tion
Ensure the unit is plugged in and power is available. The OPERATION
indicator on the display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the desired temperature. The
temperature can be set within a range of 62
°
F~86
°
F in 1
°
F
increments.
3. Press the ON/OFF button to start the unit.
TIMER OPERATION
Fig. 12
-
Remote Controller Buttons for Timer Operation
Press the SET button can set the auto−on/off time of the unit.
Set the Auto−On Time
1. Press the SET button
The Timer on indicator
displays and flashes. The last
Auto−on setting time and the signal “h” shows on the LCD
display area. Now it is ready to reset the Auto−on time to
START the operation.
2. Press the
or
button to set desired Auto−On time. Each
time you press the button, the time increases/decreases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. Once the desired time is established, there will be a three second
delay before the remote controller transmits the signal to the
unit. Then, the “h” signal disappears, and the Timer On indicator
will remain on and the set temperature will re−appear on the
LCD display window.
Set the Auto−Off Time
1. Press the SET button until the Timer On indicator
displays
and flashes. The last Auto−off setting time and the “h” signal
will be shown on the LCD display area. Now it is ready to reset
the Auto−off time to STOP the operation.
2. Press the
or
button to set desired Auto−On time. Each
time you press the button, the time increases/decreases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. Once the desired time is established, there will be a three second
delay before the remote controller transmits the signal to the
unit. Then, the “h” signal disappears, and the Timer Off indicator
will remain on and the set temperature will re−appear on the
LCD display window.
Timer Setting Example