DLFEHA: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
9
REMOTE CONTROL
IMPORTANT:
The wireless remote control can operate the unit from a
distance of up to 26 ft. (8 m) as long as there are no obstructions.
When the timer function is used, the remote control should be kept
in the vicinity of the unit (within 26 ft. (8 m)).
The remote control can perform the following basic functions:
• Turn the system
ON
and
OFF
• Select the operating mode
• Adjust room air temperature set point and fan speed
• Adjust the airflow direction.
Refer to “FUNCTION BUTTONS (HEAT PUMP ONLY)” on page 5
for
a detailed description of all the capabilities of the remote control.
Battery Installation
Two AAA 1.5v alkaline batteries (included) are required to operate the
remote control.
To install or replace batteries:
1. Slide the back cover off the control to open the battery compartment.
2. Insert the batteries. Follow the polarity markings inside the battery
compartment.
3. Replace the battery compartment cover.
NOTES:
1. When replacing batteries, do not use old batteries or a different type of
battery. This may cause the remote control to malfunction.
2. If the remote is not going to be used for several weeks, remove the
batteries. Otherwise, battery leakage may damage the remote control.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no audible beep from the indoor
unit or if the Transmission Indicator fails to light.
5. When batteries are removed, the remote control erases all programmed
settings. The control must be reprogrammed after the insertion of new
batteries.
Remote Control Operation - Quick Start
Before operation, ensure the unit is plugged in and the power is available.
AUTO Mode (Heat Pump Model Only)
In
AUTO
mode, the unit automatically selects the
COOL
,
FAN
, or
HEAT
operation based on the set temperature.
Fig. 9 — AUTO Mode
1. Press
MODE
to select
AUTO
.
2. Set your desired temperature using
TEMP
or
TEMP
3. Press
ON/OFF
to start the unit.
NOTE:
Fan speed can not be set in the
AUTO
mode.
COOL Mode
Fig. 10 — COOL Mode
1. Press
MODE
to select the
COOL
mode.
2. Set your desired temperature using
TEMP
or
TEMP
3. Press
FAN
to select the fan speed in a range of AU‘100%,
4. Press
ON/OFF
to start the unit.
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage. Handle
the control with care and avoid getting the control wet.
CAUTION
1
3
2
Turbo
1
3
2
4
Turbo