Carrier AGAGC9PNS01D, Руководство по установке

Страница: 9 / 16

AGAGC9PNS01D Gas Conversion Kit, Propane to Natural: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
9
A170117
A170132
Fig. 14 – Automatic Gas Valve (Two-Stage) with Tower Pressure
Ports
1. Remove caps that conceal adjustment screws for high heat and low
heat gas-valve regulators, see Fig. 13 or Fig. 14 .
2. Remove the high heat and low heat propane regulator adjustment
screws.
3. Remove the high heat and low heat propane gas regulator springs
(white).
4. Install the high heat and low heat natural gas regulator springs
(silver).
5. Install the high heat and low heat regulator adjustment screws.
6. Turn high heat stage adjusting screw clockwise (in) 12 full turns.
This will increase the manifold pressure closer to the natural set
point.
7. Turn low heat stage adjusting screw clockwise (in) 9.5 full turns.
This will increase the manifold pressure closer to the natural low
heat set point.
8. Do not install regulator seal caps at this time.
Modulating Gas Valve
Refer to Fig. 15 through Fig. 17 .
A11373
Fig. 15 – Propane Jumper
A11375
Fig. 16 – Removing Propane Jumper
NOTE: The Propane jumper for the modulating gas valve is very small.
Needle-nose pliers are required to remove the jumper from the valve. If
the jumper is not removed, the valve will not operate properly on natural
gas pressures.
1. Locate the round “LP GAS” sticker on the top of the gas valve.
2. Peel the sticker off and discard.
3. Note the small square opening in the top of the gas valve.
4. Note the two jumper pins inside the modulating gas valve.
5. Use needle-nosed pliers to gasp the jumper by the tab on the end.
6. Remove the small black plastic propane jumper from the gas valve.
7. Cover the opening in the gas valve with the label marked “NAT
GAS.”
A10496B
A170116B
Fig. 17 - Automatic Control Valve (Modulating) without Tower
Pressure Ports
INLET PRESSURE TAP
SET SCREW: 3/32” HEX HEAD
ACCEPTS 5/16” HOSE
CONNECTION
ON/OFF SWITCH
MANIFOLD PRESSURE TAP SET SCREW:
3/32” HEX HEAD ACCEPTS
5/16” HOSE CONNECTION
REGULATOR SEAL CAP
(REGULAR ADJ. UNDER CAP)
OUTP
1/2” NPT
INLET
1/2” NPT
OUTLET
Representative drawing only, some models may vary in appearance.
1/8” NPT
INLET
PRESSURE
TAP
INP
1/2” NPT
INLET
1/2” NPT
OUTLET
Representative drawing only, some models may vary in appearance.
ON/OFF Switch
1/2” NPT Outlet
Manifold
Pressure Tap
Inlet
Pressure Tap
Min/Max Heat Adust
(Under Cap)
GAS FL
OW
MODULATING
Turn screw 1 click per
second to adjust rate.
Clockwise to increase
rate, counter clockwise
to decrease rate.