Carrier 42PHQ007, Руководство по установке, Страница: 13 / 15

GB - 12
42PHW / 42PHQ / 42PHQ...K
Guide for the owner
When installation and tests are completed explain the Operation
and Maintenance Manual to the owner, with particular attention to
the main operating modes of the air conditioner, such as:
• Turning the unit on and off.
Guide for the owner
Description
Active carbon filter and
electrostatic filter
Photocatalytic filter
and electrostatic filter
007 009 012 014 018 024
42PHW / 42PHQ / 42PHQ...K
Table IV : Accessories
Part number
42PHW9100
42PHW9101
42PHW9102
42PHW9103
Operating test and address switch - Guide for the owner and accessories
Operating test
This procedure is used to check the operation after unit installation.
• Press the EMER. button continuously for 5~10 seconds.
The unit will now be in Test Mode.
• Press the EMER. button once more after checking, to activate
the remote control. If there is any input signal (remote control
signal or EMER. button press) during test operation, the TEST
mode will change to the input signal mode.
• The setting conditions of the test operation are as follows:
- Operating mode: COOL
- Fan speed: HIGH
- Timer mode: Disabled
- Discharge air direction: SWING
NOTE:
• Indoor fan speed will be "HIGH" in Test operation.
• The swing motor will operate when the indoor fan is operated.
• Operate the unit in accordance with the Owner's Manual and
check the following:
a. Indoor unit.
- Do all switches operate normally?
- Does each light come on normally?
- Do the horizontal louvres operate normally?
- Is the drain correct?
b. Outdoor unit.
- Is there any abnormal noise or vibration during operation?
- Is there any gas leakage?
Address switch
If you are installing two indoor units in the same room, it is
necessary for you to assign each unit its own address so each can
be operated by its own remote control.
One address switch is on the back of remote control, and the
other is in the PCB side.
The address switch is set to A when you purchase the unit.
• Remote control
- Remove the lid of the battery case.
- Assign the address switch of one remote control to B.
- Press the RST button with a sharp object.
• Indoor unit
- Turn off the unit and pull out the power plug.
- Remove the front panel and terminal block cover.
- Assign the address switch of one indoor unit to B.
Address switch
A B
SLEEP
TEMP.
CLOCK EVERYDAY MINUTE HOUR
MODE
ON OFF
TIMER
CANCEL SET
TA RST
I / O
FAN FLAP
EMER.
• Functions of the remote control.
• Removal and cleaning of the air filters.
Leave the two installation manuals for the indoor and outdoor
units with the owner for future use during maintenance operations
or for any other needs.