OM-40MAQ-07 Specifications subject to change without notice.
7
REMOTE CONTROL FUNCTIONS
Pressing ON/OFF
When the air conditioner is not in operation, the remote control
displays the last set point and mode.
• Press ON/OFF to start the unit.
- The unit starts in the last operating mode and set point. The
ON/OFF
indicator appears.
• Press ON/OFF to stop the unit.
- All the indicator lights on the unit go out, and the remote
control displays the set point and mode.
NOTE: If ON/OFF is pressed too soon after a stop, the
compressor will not start for 3 to 4 minutes due to the inherent
protection against frequent compressor cycling. The unit only
emits an audible beep when the signals are received correctly.
Selecting an Operating Mode
Use
OPERATING MODE
to select one of the available modes.
Fig. 7 — Operating Modes
Setting the Room Temperature Set Point
Press the increase temperature set point
and decrease
buttons
to raise or lower the temperature. The unit confirms the signal receipt
with a beep and the value of the set temperature appears on the display
and changes accordingly. The temperature can be set between 62
°
F
(17
°
C) and 86
°
F (30
°
C) in increments of 1
°
F or 1
°
C.
NOTE:
In the
COOLING
mode, if the temperature selected is higher
than the room temperature, the unit will not start. The same applies for
the
HEATING
mode if the selected temperature is lower than the
room temperature.
Selecting the Fan Speed
Fig. 8 — Fan Speeds
1. Press
FAN
to select the fan speed.
NOTE:
When the unit is on, the fan runs continuously in cooling or
heating. When in heating, there might be situations where the fan will
slow down or shut off to prevent cold blow.
Select the Up-Down Louver Position
To optimize comfort, the
Up-Down
louver operates in a preset range.
Fig. 9 — Louver Position
The up-down airflow louver can be adjusted by pressing
DIRECT
on
the remote control and can be set to be stationary or moving
continuously pressing
SWING
. The up-down louver position is stored
in the settings, however it is deactivated when the
TURBO
or
MANUAL
settings are set, or when a power interruption takes place.
Air Direction
Press
DIRECT
repeatedly to choose one of the up-down louver positions.
Every time this button is pushed, the specific louver swings by 6 degrees.
In the
COOLING
,
DRY
, and
FAN ONLY
modes, the louver swings
in the cooling range. In the
HEATING
mode, the louver swings in the
heating range.
NOTE:
Always use the remote control to adjust the up-down louver
position, otherwise abnormal operation may occur. If the up-down
louver is manually adjusted out of its range, power the unit off and
then back on again
.
Auto Swing
For automatic up-down louver swing, push
SWING
.
Select Right-Left Direction of the Louver
The right-left louvers can be adjusted manually to direct the airflow to
achieve optimal comfort in the space.
Fig. 10 — Louver
Fig. 11 — Deflector Rod
Ÿ
ź
AUTO
LOW
MED
HIGH
COOLING
HEATING
Deflector rod
