1
5
2
6
3
4
7
11
ON
OFF
Should you need spare parts, you will find a complete list of the available parts under
carrerarc.com
in the service area.
Problem
Cause
Solution
Boat does not move
Either the switch on the controller or the boat is set to OFF.
Switch on.
There is no rechargeable battery in the boat or the battery is too
weak.
Insert charged battery.
The overheat protection has caused the boat’s motor to cut out due to
excess temperature.
Switch off the receiver.
Leave the RC boat to cool down for approx. 30 minutes.
The battery or rechargeable battery in the transmitter or boat is too
weak.
Insert new battery or recharged battery.
The boat is very warm.
Allow the RC boat to cool down for about 30 minutes.
Boat cannot be controlled
Boat starts moving unintentionally.
First turn on the transmitter, only then the boat
.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
Controller functions
Function can be changed by
remounting the steering unit
To remount, unsrew the three screws on
the inside of the steering unit and screw
them to the opposite side.
Remove the cover plate from the other
side and mount the steering wheel to
the opposite side. Insert and tighten the
three inner screws again. Finished!
When the controller is switched on,
the red LED lamps at the front of the
controller are lit.
THTRIMM
Fine speed regulation
Here you can adjust the braking effect
on your boat.
Steering digital proportional
Gas pedal to the rear: forwards
Gas pedal to the front: braking,
or backwards
TRIMMsteering
Fine steering adjustment
If the boat does not run in a straight
line, you can make fine steering adjust-
ments here.
The 2.4 GHz controller is suitable for
left- or right-handers and can be
adjusted as necessary by unscrewing
and refixing the steering unit accord-
ingly.
Range control
On leaving the radio frequency, the boat
automatically returns to within range
radius.
Troubleshooting
