WARNING:
Maintenance and repairs performed by unauthorized per-
sonnel could result in damage or injury. Keep adjustments according to
specifications.
WARNING:
Electrical components of this machine can "short-out" if ex-
posed to water or moisture. Keep the electrical components of the ma-
chine dry. Wipe the machine down after each use. For storage,
keep the machine in a dry building.
WARNING:
To prevent damage to the power cord, do not let the brush,
pad, pad driver or wheels touch the power cord when the machine is run-
ning. Always lift the cord over the machine. Do not pull the power cord to
move the machine.
WARNING:
Operating a machine without observing instructional infor-
mation could result in injury or damage. Read manual before attempting to
operate.
WARNING:
Use of this machine as a step or furniture could result in in-
jury or damage. Do not use this machine as a step or furniture. Do not ride
on this machine.
WARNING:
To avoid injury keep hands, feet and loose clothing away
from all moving parts of this machine.
WARNING:
Water solutions or cleaning materials used with this type of
machine can leave wet areas on the floor surface. These areas can
cause a dangerous condition for the operator or other persons. Always put
CAUTION signs near the area being cleaned.
CAUTION:
The machine is heavy. Use care in transporting it.
Maintenance of the Machine
Clean
your machine frequently. It will have longer life and need fewer
repairs. Replace damaged or worn parts with the correct CCS parts.
Keep
nuts and bolts tight, if you hear or feel a rattling, examine the han-
dle bolts and be sure they are tight, loose bolts on an oscillating machine
can cause premature and undue wear.
Remove
or blow dust and dirt from the motor frequently.
Machine Specifications
Page 4
Model
Trinity OP 18” 3 Speed
Voltage
115/240 V 60 hz
Power Cord
12/3 50’
Motor
1 HP 143t Frame
RPM
1800 RPM
Machine Weight
110 #’s With Spray
Wiring Instructions
Simply plug the 12/3 wire male into the 12/3 wire female
connector.
Attach handle by inserting the four bolts, 2 per
side, through the base plate and tighten the the
3/8 nuts with a 9/16 wrench.
Make sure the motor plate is moved forward
away from the handle as far as it can go, or to
put it another way, make sure the handle arms
are moved to the “back” of the motor plate.
Attaching handle to base
Insert 3/8 plastic hose into the slot in the base plate, pull
tube through until it fits up into the tube fitting on the
spray heads.
